DTC TABLE [ADVANCED KEYLESS AND START SYSTEM]

id0902e1347100

DTC

Detection condition

Reference

M-MDS display

B1026:51

Steering lock unit not programmed

(See DTC B1026:51 [ADVANCED KEYLESS AND START SYSTEM].)

B1026:87

Communication error between keyless control module and steering lock unit

(See DTC B1026:87 [ADVANCED KEYLESS AND START SYSTEM].)

B1026:96

Steering lock unit status malfunction signal detected

(See DTC B1026:96 [ADVANCED KEYLESS AND START SYSTEM].)

B102B:51

No advanced key programming record (programming never performed in past)

(See DTC B102B:51 [ADVANCED KEYLESS AND START SYSTEM].)

B108A:29

Push switch off signal detected while ignition switch is at ON

(See DTC B108A:29 [ADVANCED KEYLESS AND START SYSTEM].)

B10A5:12

Keyless beeper output voltage malfunction

(See DTC B10A5:12 [ADVANCED KEYLESS AND START SYSTEM].)

B10C6:1F

Cannot receive signal correctly from keyless antenna (exterior, rear)

(See DTC B10C6:1F [ADVANCED KEYLESS AND START SYSTEM].)

B10C7:1F

Cannot receive signal correctly from keyless antenna (interior, rear)

(See DTC B10C7:1F [ADVANCED KEYLESS AND START SYSTEM].)

B10C8:1F^*1

Cannot receive signal correctly from keyless antenna (interior, center)

(See DTC B10C8:1F [ADVANCED KEYLESS AND START SYSTEM].)

B10C9:1F

Cannot receive signal correctly from keyless antenna (interior, front)

(See DTC B10C9:1F [ADVANCED KEYLESS AND START SYSTEM].)

B10D1:23

Request switch (LF) ON signal detected while driving

(See DTC B10D1:23 [ADVANCED KEYLESS AND START SYSTEM].)

B10D3:23

Request switch (RF) ON signal detected while driving

(See DTC B10D3:23 [ADVANCED KEYLESS AND START SYSTEM].)

B10E7:16

Keyless control module IG1 power voltage malfunction

(See DTC B10E7:16 [ADVANCED KEYLESS AND START SYSTEM].)

B113E:11

Liftgate opener switch (3HB/5HB)/Trunk lid opener switch (4SD) input voltage malfunction

(See DTC B113E:11 [ADVANCED KEYLESS AND START SYSTEM].)

B11FD:1F

Cannot receive signal correctly from keyless antenna (LF)

(See DTC B11FD:1F [ADVANCED KEYLESS AND START SYSTEM].)

B1210:1F

Cannot receive signal correctly from keyless antenna (RF)

(See DTC B1210:1F [ADVANCED KEYLESS AND START SYSTEM].)

P1794:16

Keyless control module power voltage low (power from P/W 20 A fuse)

(See DTC P1794:16, P1794:17 [ADVANCED KEYLESS AND START SYSTEM].)

P1794:17

Keyless control module power voltage rising (power from P/W 20 A fuse)

U0001:88

Module communication error (HS-CAN)

(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L.H.D.)].)

(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D.)].)

U0028:87

Correct data cannot be received from BCM (no response for 10 times)

(See DTC U0028:87 [ADVANCED KEYLESS AND START SYSTEM].)

U0100:00

Communication error (no response) between keyless control module and PCM

(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L.H.D.)].)

(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D.)].)

U0401:68

Correct data cannot be received from PCM

(See DTC U0401:68 [ADVANCED KEYLESS AND START SYSTEM].)

U201F:00

Communication error between keyless control module and keyless receiver

(See DTC U201F:00 [ADVANCED KEYLESS AND START SYSTEM].)

U201F:13

Keyless receiver not connecting

(See DTC U201F:13 [ADVANCED KEYLESS AND START SYSTEM].)

U2100:00

Configuration error

(See DTC U2100:00 [ADVANCED KEYLESS AND START SYSTEM].)

U3000:41

Keyless control module internal malfunction

(See DTC U3000:41 [ADVANCED KEYLESS AND START SYSTEM].)

U3003:16

Keyless control module power voltage low (power from ROOM 15 A fuse)

(See DTC U3003:16, U3003:17 [ADVANCED KEYLESS AND START SYSTEM].)

U3003:17

Keyless control module power voltage rising (power from ROOM 15 A fuse)

U3004:16

Keyless control module ACC power voltage malfunction

(See DTC U3004:16 [ADVANCED KEYLESS AND START SYSTEM].)

DTC	Detection condition	Reference
B1026:51	Steering lock unit not programmed	(See DTC B1026:51 [ADVANCED KEYLESS AND START SYSTEM].)
B1026:87	Communication error between keyless control module and steering lock unit	(See DTC B1026:87 [ADVANCED KEYLESS AND START SYSTEM].)
B1026:96	Steering lock unit status malfunction signal detected	(See DTC B1026:96 [ADVANCED KEYLESS AND START SYSTEM].)
B102B:51	No advanced key programming record (programming never performed in past)	(See DTC B102B:51 [ADVANCED KEYLESS AND START SYSTEM].)
B108A:29	Push switch off signal detected while ignition switch is at ON	(See DTC B108A:29 [ADVANCED KEYLESS AND START SYSTEM].)
B10A5:12	Keyless beeper output voltage malfunction	(See DTC B10A5:12 [ADVANCED KEYLESS AND START SYSTEM].)
B10C6:1F	Cannot receive signal correctly from keyless antenna (exterior, rear)	(See DTC B10C6:1F [ADVANCED KEYLESS AND START SYSTEM].)
B10C7:1F	Cannot receive signal correctly from keyless antenna (interior, rear)	(See DTC B10C7:1F [ADVANCED KEYLESS AND START SYSTEM].)
B10C8:1F^*1	Cannot receive signal correctly from keyless antenna (interior, center)	(See DTC B10C8:1F [ADVANCED KEYLESS AND START SYSTEM].)
B10C9:1F	Cannot receive signal correctly from keyless antenna (interior, front)	(See DTC B10C9:1F [ADVANCED KEYLESS AND START SYSTEM].)
B10D1:23	Request switch (LF) ON signal detected while driving	(See DTC B10D1:23 [ADVANCED KEYLESS AND START SYSTEM].)
B10D3:23	Request switch (RF) ON signal detected while driving	(See DTC B10D3:23 [ADVANCED KEYLESS AND START SYSTEM].)
B10E7:16	Keyless control module IG1 power voltage malfunction	(See DTC B10E7:16 [ADVANCED KEYLESS AND START SYSTEM].)
B113E:11	Liftgate opener switch (3HB/5HB)/Trunk lid opener switch (4SD) input voltage malfunction	(See DTC B113E:11 [ADVANCED KEYLESS AND START SYSTEM].)
B11FD:1F	Cannot receive signal correctly from keyless antenna (LF)	(See DTC B11FD:1F [ADVANCED KEYLESS AND START SYSTEM].)
B1210:1F	Cannot receive signal correctly from keyless antenna (RF)	(See DTC B1210:1F [ADVANCED KEYLESS AND START SYSTEM].)
P1794:16	Keyless control module power voltage low (power from P/W 20 A fuse)	(See DTC P1794:16, P1794:17 [ADVANCED KEYLESS AND START SYSTEM].)
P1794:17	Keyless control module power voltage rising (power from P/W 20 A fuse)
U0001:88	Module communication error (HS-CAN)	(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L.H.D.)].) (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D.)].)
U0028:87	Correct data cannot be received from BCM (no response for 10 times)	(See DTC U0028:87 [ADVANCED KEYLESS AND START SYSTEM].)
U0100:00	Communication error (no response) between keyless control module and PCM	(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L.H.D.)].) (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D.)].)
U0401:68	Correct data cannot be received from PCM	(See DTC U0401:68 [ADVANCED KEYLESS AND START SYSTEM].)
U201F:00	Communication error between keyless control module and keyless receiver	(See DTC U201F:00 [ADVANCED KEYLESS AND START SYSTEM].)
U201F:13	Keyless receiver not connecting	(See DTC U201F:13 [ADVANCED KEYLESS AND START SYSTEM].)
U2100:00	Configuration error	(See DTC U2100:00 [ADVANCED KEYLESS AND START SYSTEM].)
U3000:41	Keyless control module internal malfunction	(See DTC U3000:41 [ADVANCED KEYLESS AND START SYSTEM].)
U3003:16	Keyless control module power voltage low (power from ROOM 15 A fuse)	(See DTC U3003:16, U3003:17 [ADVANCED KEYLESS AND START SYSTEM].)
U3003:17	Keyless control module power voltage rising (power from ROOM 15 A fuse)
U3004:16	Keyless control module ACC power voltage malfunction	(See DTC U3004:16 [ADVANCED KEYLESS AND START SYSTEM].)

*1 :4SD

With Immobilizer System

DTC		Detection condition	Reference
M-MDS display	Security light flashing pattern	Detection condition	Reference
B10D5:13		• Coil antenna malfunction • The PCM determined a malfunction in the coil antenna even though it is normal.	(See SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10D7:05		Key ID number program error	(See SECURITY LIGHT: 13, DTC: B10D7:05/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10D7:51		Keyless control module detected unprogrammed key ID number.	(See SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10D7:81		The keyless control module cannot read key ID number data normally.	(See SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10D7:94		The key ID number data cannot be read.	(See SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10D8:00		Only one key has been programmed.	(See SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10D9:87		No detected communication with the coil antenna.	(See SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10DA:51		Communication error between keyless control module and PCM (data transfer error)	(See SECURITY LIGHT: 22, DTC: B10DA:51/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
B10DA:62		ID number data between keyless control module and PCM are different.	(See SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)
U0100:87		Communication error between the keyless control module and the PCM (no response/condition mismatch)	(See SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (ADVANCED KEYLESS AND START SYSTEM)].)