DTC TABLE [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)]

id0902e5347100

Note

•  The security light flashes or illuminates under the following conditions when the ignition switch is turned to the LOCK or ACC position.

•  There is a malfunction:

―  DTC 16 or below: Flashes for approx. 1 min and the DTC flash pattern indicated in the table below repeats 10 times.

―  DTC 21 or higher: Illuminates for approx. 1 min and the DTC flash pattern indicated in the table below repeats 10 times.

―  If more than one DTC is detected, only the DTC with the lowest number is displayed.

•  There is no malfunction

―  The security light illuminates for approx. 3 s and then turns off.

DTC				Detection Condition	Page
Security light flashing pattern		M-MDS display*
		Instrument cluster	PCM
11		B10D9:87	P1260:00	No detected communication with the coil antenna.	(See SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
12		B10D5:13	P1260:00	•  Coil antenna malfunction •  The PCM determined a malfunction in the coil antenna even though it is normal.	(See SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
13		B10D7:05	P1260:00	Key ID number program error	(See SECURITY LIGHT: 13, DTC: B10D7:05/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
		B10D7:94	P1260:00	The key ID number data cannot be read.	(See SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
14		B10D7:81	P1260:00	The instrument cluster cannot read key ID number data normally.	(See SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
15		B10D7:51	P1260:00	The instrument cluster has detected an unprogrammed key ID number.	(See SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
16		U0100:87	P1260:00	Communication error between the instrument cluster and the PCM (no response)	(See SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
21		B10D8:00	P1260:00	Only one key has been programmed.	(See SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
22		B10DA:51	P1260:00	Communication error between the instrument cluster and the PCM (data transfer failure)	(See SECURITY LIGHT: 22, DTC: B10DA:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
23		B10DA:62	P1260:00	Communication error between the instrument cluster and the PCM (condition mismatch)	(See SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
Not illuminated		U0001:88	U0073:00	Module communication error (HS-CAN)	(See DTC U0001:88, U0073:00 [MULTIPLEX COMMUNICATION SYSTEM].)
		U0100:00	-	PCM communication error	(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM].)