SUPPLIER IDENTIFICATION PROCEDURE [AUDIO]

id0902f6803800

Note

•  When asking the supplier (service center) for repair or replacement, identify the supplier and fill in the Audio Repair Order Form using the following procedures.

Identification Using Label or Inscribed Lettering

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Front scuff plate (L.H.D.) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (L.H.D.) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Rear console (L.H.D.) (See REAR CONSOLE REMOVAL/INSTALLATION.)

(4)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(5)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [B65M-R].)

(6)  Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(7)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(8)  Passenger’s side lower panel (L.H.D.) (See LOWER PANEL REMOVAL/INSTALLATION.)

(9)  Center panel unit (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)

3.  Verify the supplier indicated on the label attached on each unit.

am2uuw00000673

Verify Using the Diagnostic Assist Function

1.  Turn the ignition switch to the ACC or ON position.

2.  Turn the audio unit power to on.

3.  While pressing the POWER/VOLUME switch, simultaneously press the Preset 5 switch for 3 s or more.

am2uuw00000661

4.  Identify the supplier code by referring to the LCD.

am2uuw00000772

Supplier code	Supplier name
01	SANYO Automedia
02	Panasonic
03	Clarion
04	Pioneer
05	VISTEON

Note

•  The supplier code can also be identified from the DTC displays screen.

am2zzw00000726

5.  To stop the diagnostic assist function by either turning off the audio unit power or by turning the ignition switch to the LOCK position.