HAZARD WARNING SWITCH REMOVAL/INSTALLATION

id091800470100

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION)

(2)  Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION)

(3)  Rear console (L.H.D.) (See REAR CONSOLE REMOVAL/INSTALLATION.)

(4)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R])

(5)  Side wall (See SIDE WALL REMOVAL/INSTALLATION)

(6)  Front console component (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.)

(7)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION)

(8)  Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(9)  Glove compartment (Vehicles with center panel unit) (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(10)  Center panel unit (Vehicles with center panel unit) (See CENTER PANEL UNIT REMOVAL/INSTALLATION.)

(11)  Center panel (Vehicles without center panel unit) (See CENTER PANEL REMOVAL/INSTALLATION.)

3.  Remove the hazard warning switch in the direction of the arrow (2) shown in the figure while pressing the hazard warning switch tabs in the direction of the arrow (1).

am2zzw00002497

4.  Install in the reverse order of removal.