FRONT ACCESSORY SOCKET INSPECTION
id092100900800
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)
2. Remove the following parts:
- (1) Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
- (2) Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (3) Upper panel (See UPPER PANEL REMOVAL.) (See UPPER PANEL INSTALLATION.)
- (4) Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)
- (5) Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [C66M-R].) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [D66M-R].)
- (6) Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)
- (7) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
- (8) Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
- (9) Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
- (10) Front console (See FRONT CONSOLE REMOVAL/INSTALLATION.)
- (11) Front accessory socket (See FRONT ACCESSORY SOCKET REMOVAL/INSTALLATION.)
3. Connect the tester probe to the position shown in the figure and verify that there is continuity.
-
• If it cannot be verified, replace the front accessory socket.
