Diagnostic procedure
STEP
|
INSPECTION
|
ACTION
|
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related Service Bulletins and or/on-line repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
INSPECT TR SWITCH
• Turn the ignition switch to the LOCK position.
• Disconnect the TR switch connector.
• Inspect for resistance between TR switch terminals B and C (part-side).
• Is the resistance normal?
|
Yes
|
Go to the next step.
|
No
|
Adjust or replace the TR switch, then go to the next step.
|
||
4
|
VERIFY TROUBLESHOOTING OF DTC P0706 COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC from the memory using the WDS or equivalent.
• Drive the vehicle in each range (D and R) for 100 s or more under the following conditions:
• Is the PENDING CODE present?
|
Yes
|
Replace the PCM, then go to the next step.
|
No
|
No concern is detected. Go to the next step.
|
||
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
(See AFTER REPAIR PROCEDURE.)
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE.)
|
No
|
DTC troubleshooting completed.
|