SOLAR RADIATION SENSOR INSPECTION

id074000802900

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(4)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(5)  Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(6)  Tuner and amp unit (TAU) (With Tuner and amp unit (TAU)) (See TUNER AND AMP UNIT (TAU) REMOVAL/INSTALLATION.)

(7)  Blower unit (See BLOWER UNIT REMOVAL/INSTALLATION.)

3.  Remove the solar radiation sensor. (See SOLAR RADIATION SENSOR REMOVAL/INSTALLATION.)

4.  Shine a fluorescent light or expose the solar radiation sensor to natural sunlight.

5.  Connect the positive (+) lead to terminal A and negative (-) lead to terminals B, C of the solar radiation sensor, and verify that the voltage value is output.

am6xuw00006144

•  If the voltage is 0 V, replace the solar radiation sensor. (See SOLAR RADIATION SENSOR REMOVAL/INSTALLATION.)