DASH-ELECTRICAL SUPPLY UNIT REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]

id0740a1704400

Caution

•  When replacing the dash-electrical supply unit, perform the configuration to assure that the system operates correctly.

1.  To replace the dash-electrical supply unit, perform the following procedure.

(1)  Connect the M-MDS to the DLC-2.

(2)  Switch the main power ON (READY off).

(3)  Activate the M-MDS and perform the following procedure.

1)  Press [Start] to start the vehicle identification.

2)  Press the [Toolbox] tab.

3)  Press the [Work Support] icon.

4)  Press [Configuration].

5)  Press [Run] to perform the configuration.

6)  Press [DASH_ESU].

7)  When [Install the new ECU] is displayed, move to the dash-electrical supply unit replacement procedure.

2.  Remove the selector lever knob. (See SELECTOR LEVER REMOVAL/INSTALLATION [A71M].)

3.  Disconnect the negative lead-acid battery terminal. (See NEGATIVE LEAD-ACID BATTERY TERMINAL DISCONNECTION/CONNECTION.)

4.  Remove the following parts:

(1)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(2)  Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION.)

(3)  Passenger-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(4)  Passenger-side scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION.)

(5)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(6)  Glove compartment(See GLOVE COMPARTMENT REMOVAL/INSTALLATION [(E)].)

(7)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(8)  Passenger-side lower panel(See PASSENGER-SIDE LOWER PANEL REMOVAL [(E)].) (See PASSENGER-SIDE LOWER PANEL INSTALLATION [(E)].)

5.  Disconnect the connectors.

a30zzw00002862

6.  Remove the screws.

7.  Remove the dash-electrical supply unit.

8.  Install in the reverse order of removal.

9.  If the dash-electrical supply unit is replaced, perform the following procedure.

(1)  Return to the M-MDS operation and press [Continue].

(2)  When the M-MDS processing is completed, press [Next].

(3)  When the M-MDS processing is completed, press [Next].

(4)  Verify that the following conditions/operations are met/completed, mark the check boxes, and then press [Next].

•  Switch the main power ON (READY off)

•  Install battery charger to vehicle

•  Lead-acid battery voltage: 11.6 V or more

•  Connect power cable to M-MDS

•  Front doors on both sides and liftgate are open

(5)  Press [Finish].

(6)  Switch the main power OFF.

(7)  Switch the main power ON (READY off) to complete the global central configuration (GCC) for the dash-electrical supply unit.

(8)  Clear the DTC. (See CLEARING DTC.)