SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)]

id0902e5356800

DTC

Security light flashing pattern

16

Communication error with PCM (No response)

M-MDS display

Instrument cluster

U0100:87

PCM

P1260:00
DETECTION CONDITION
•  Communication error between instrument cluster and PCM (no response).
POSSIBLE CAUSE
•  Multiplex communication system DTC is stored (CAN line)
•  PCM malfunction
•  Instrument cluster malfunction

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
CONFIRM MULTIPLEX COMMUNICATION SYSTEM DTC
•  Clear the DTC from the instrument cluster and PCM using the M-MDS.
•  Perform the immobilizer system DTC inspection using the M-MDS.
•  Is the following DTC present?
―  Instrument cluster: U0001:88
―  PCM: U0073:00
Yes
Go to the applicable DTC inspection.
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L.H.D. (EXCEPT MZR-CD 2.2, MZR 2.0 DISI i-stop))].)
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (L.H.D. (MZR-CD 2.2, MZR 2.0 DISI i-stop))].)
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D. (MZR 1.5))].)
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D. (MZR-CD 2.2, MZR 2.0 DISI i-stop))].)
(See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM (R.H.D. (EXCEPT MZR-CD 2.2, MZR 2.0 DISI i-stop, MZR 1.5))].)
No
Go to the next step.
2
VERIFY PCM MALFUNCTION
•  Clear the DTC from the instrument cluster and PCM using the M-MDS.
•  Perform the immobilizer system DTC inspection using the M-MDS.
•  Is the following DTC present?
―  Instrument cluster: U0100:87
―  PCM: 1260:00
Yes
Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
(See PCM REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
(See PCM REMOVAL/INSTALLATION [MZR 2.0 DISI i-stop].)
(See PCM REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo].)
(See PCM REMOVAL/INSTALLATION [MZ-CD 1.6].)
(See PCM REMOVAL/INSTALLATION [MZR-CD 2.2].)
(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)
No
Go to Step 4.
3
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC from the instrument cluster and PCM using the M-MDS.
•  Perform the immobilizer system DTC inspection using the M-MDS.
•  Is the following DTC present?
―  Instrument cluster: U0100:87
―  PCM: 1260:00
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
4
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)].)
No
DTC troubleshooting completed.