REAR VEHICLE MONITORING CONTROL MODULE REMOVAL/INSTALLATION
id092200165100
-
Caution
-
1. Disconnect the negative battery cable.
2. Peel off the seaming welt.
3. Remove the following parts: (4SD)
- (1) Trunk mat
- (2) Trunk board
- (3) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
- (4) Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
- (5) Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION.)
- (6) Splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION.)
- (7) Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION.)
4. Remove the following parts: (5HB)
- (1) Service hole cover
- (2) Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION.)
- (3) Splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION.)
- (4) Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION.)
5. Remove the following parts: (Wagon)
- (1) Trunk mat
- (2) Trunk board
- (3) Sub-trunk
- (4) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
- (5) Rear scuff plate (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
- (6) Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
- (7) Trunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)
- (8) Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
- (9) Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION.)
- (10) Splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION.)
- (11) Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION.)
6. Disconnect the connector.
7. Disconnect the short cord connector.
8. Remove the nuts.
9. Remove the rear vehicle monitoring control module.
10. Install in the reverse order of removal.
11. When replacing the rear vehicle monitoring control module (RH), perform the rear vehicle monitoring configuration. (See REAR VEHICLE MONITORING CONTROL MODULE CONFIGURATION.)
12. Perform radar aiming. (See REAR VEHICLE MONITORING RADAR AIMING.)
