CLIMATE CONTROL UNIT REMOVAL/INSTALLATION

id074000807400

Note

•  The climate control unit prior to replacement stores the vehicle specification information.

•  The new climate control unit does not store any vehicle specification information.

•  When the ignition is switched ON after the climate control unit is replaced, the climate control unit reads the vehicle specification information sent via CAN transmission from the instrument cluster, and stores the vehicle specification information.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(2)  Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(3)  Bonnet release lever (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(4)  Fuel-filler lid opener lever (See FUEL-FILLER LID OPENER AND LEVER REMOVAL/INSTALLATION.)

(5)  Driver-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(6)  Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(7)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(8)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(9)  Passenger-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(10)  Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(11)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(12)  Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(13)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [C66M-R].)

(14)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(15)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)

(16)  Rear console component (See REAR CONSOLE REMOVAL/INSTALLATION.)

(17)  Center lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

3.  Remove the screws.

am6xuw00009510

4.  Remove the climate control unit while detaching the pins.

5.  Disconnect the connectors.

6.  Install in the reverse order of removal.

7.  Switch the ignition ON and perform the climate control unit automatic configuration.

8.  Perform the DTC inspection for the climate control unit using the M-MDS. (See FOREWORD [CLIMATE CONTROL UNIT (FULL-AUTO AIR CONDITIONER)].)

•  If a DTC is detected, perform troubleshooting according to the DTC. (See DTC TABLE [CLIMATE CONTROL UNIT (FULL-AUTO AIR CONDITIONER)].)