FRONT DRAIN HOSE INSTALLATION

id091500801400

Caution

•  If the front drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and the headliner, always make sure there is no interference with the front drain hose. Fix any problem if found.

1.  Apply soapy water to the front drain hose inserting area.

2.  Insert one end (the wider end) of the front drain hose into the sunroof frame.

3.  Install the front drain hose to the clips, parallel to the pillar and free of slack.

4.  Insert the front drain hose joint into the hinge pillar inner hole.

5.  Connect the auto-dimming mirror connector. (vehicles with auto-dimming mirror)

6.  Install the following parts:

(1)  Headliner (See HEADLINER REMOVAL/INSTALLATION.)

(2)  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

(3)  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)

(4)  Map light (See MAP LIGHT REMOVAL/INSTALLATION.)

(5)  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(6)  Trunk side upper trim (5HB) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(7)  Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(8)  Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)

(9)  B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)

(10)  Upper anchor of the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)

(11)  B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)

(12)  Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(13)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(14)  Sunroof seaming welt

(15)  Dashboard (See DASHBOARD REMOVAL/INSTALLATION.)

(16)  Windshield wiper motor (See WINDSHIELD WIPER MOTOR REMOVAL/INSTALLATION.)

(17)  Cowl grille (See COWL GRILLE REMOVAL/INSTALLATION.)

(18)  Front fender molding (See COWL GRILLE REMOVAL/INSTALLATION.)

(19)  Windshield wiper arm and blade (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

(20)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(21)  Information display (See INFORMATION DISPLAY REMOVAL/INSTALLATION.)

(22)  Hole cover (See HOLE COVER REMOVAL/INSTALLATION.)

(23)  Dashboard upper panel (See DASHBOARD UPPER PANEL REMOVAL/INSTALLATION.)

(24)  Center cover (See CENTER COVER REMOVAL/INSTALLATION.)

(25)  Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

(26)  Climate control unit (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER].) (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].)

(27)  Audio unit (See AUDIO UNIT REMOVAL/INSTALLATION.)

(28)  Center panel (See CENTER PANEL REMOVAL/INSTALLATION.)

(29)  Steering shaft (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)

(30)  Joint cover (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)

(31)  Combination switch (See COMBINATION SWITCH REMOVAL/INSTALLATION.)

(32)  Column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

(33)  Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)

(34)  Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)

(35)  Lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(36)  Bonnet release lever from the lower panel (See BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)

(37)  Selector lever component (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(38)  Shift lever component (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(39)  Console (See CONSOLE REMOVAL/INSTALLATION.)

(40)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(41)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(42)  Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(43)  Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

(44)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(45)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(46)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(47)  Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(48)  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(49)  Front doors (See FRONT DOOR REMOVAL/INSTALLATION.)

7.  Connect the rain sensor connector. (Vehicles with auto light / wiper system)

8.  Install the rain sensor cover. (Vehicles with auto light / wiper system) (See RAIN SENSOR REMOVAL/INSTALLATION.)

9.  Install the seaming welt.

10.  Connect the negative battery cable.