REAR MAP LIGHT REMOVAL/INSTALLATION
id091800810500
1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)
2. Remove the following parts:
- (1) Sunroof seaming welt (with sunroof system) (See SUNROOF UNIT REMOVAL/INSTALLATION.)
-
- (2) A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
-
- (3) Front map light (See FRONT MAP LIGHT REMOVAL/INSTALLATION.)
-
- (4) Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)
-
- (5) Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)
-
- (6) Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
-
- (7) Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
-
- (8) Lower decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
-
- (9) Bonnet release lever (See BONNET RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)
-
- (10) Fuel-filler lid opener lever (See FUEL-FILLER LID OPENER AND LEVER REMOVAL/INSTALLATION.)
-
- (11) Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
-
- (12) Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
-
- (13) B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
-
- (14) Adjust anchor cover on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
-
- (15) Upper anchor installation bolt on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
-
- (16) B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
-
- (17) Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)
-
- (18) Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)
-
- (19) Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)
-
- (20) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
-
- (21) Bass-box (with Bose®) (See BASS-BOX REMOVAL/INSTALLATION.)
-
- (22) Third-row seat cushion (See THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION.)
-
- (23) Third-row seat back component (See THIRD-ROW SEAT BACK COMPONENT REMOVAL/INSTALLATION.)
-
- (24) Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
-
- (25) D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)
-
- (26) C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
-
- (27) Headliner (See HEADLINER REMOVAL/INSTALLATION.)
-
3. Disconnect the connector.
-
Caution
-
• When removing the rear map light from the bracket, hold the rear map light on the lens side with a hand. Otherwise, it may fall off and be damaged.
4. While pressing the hooks of the rear map light in the directions of arrows (1) shown in the figure, pull the rear map light in the direction of arrow (2) to detach the hooks of the rear map light from the bracket.
5. Remove the rear map light.
6. Install in the reverse order of removal.
