REAR MAP LIGHT INSPECTION

id091800810600


Bulb type

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

1.  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
2.  Front map light (See FRONT MAP LIGHT REMOVAL/INSTALLATION.)
3.  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)
4.  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)
5.  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
6.  Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
7.  Lower decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
8.  Bonnet release lever (See BONNET RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)
9.  Fuel-filler lid opener lever (See FUEL-FILLER LID OPENER AND LEVER REMOVAL/INSTALLATION.)
10.  Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
11.  Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
12.  B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
13.  Adjust anchor cover on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
14.  Upper anchor installation bolt on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
15.  B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
16.  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)
17.  Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)
18.  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
19.  Bass-box (with Bose®) (See BASS-BOX REMOVAL/INSTALLATION.)
20.  Third-row seat cushion (See THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION.)
21.  Third-row seat back component (See THIRD-ROW SEAT BACK COMPONENT REMOVAL/INSTALLATION.)
22.  Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
23.  D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)
24.  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
25.  Headliner (See HEADLINER REMOVAL/INSTALLATION.)

3.  Remove the rear map light. (See REAR MAP LIGHT REMOVAL/INSTALLATION.)

4.  Verify that the continuity between the rear map light terminals is as indicated in the table.

ac8jjw00001509
ac8wzw00001228

•  If not as indicated in the table, replace the rear map light or the rear map light bulb. (See REAR MAP LIGHT REMOVAL/INSTALLATION.) (See REAR MAP LIGHT BULB REMOVAL/INSTALLATION.)


LED Type

Note
•  The rear map light LED is integrated with the rear map light.
•  If the rear map light LED is replaced, replace it with the rear map light as a single unit. (See REAR MAP LIGHT REMOVAL/INSTALLATION.)

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

1.  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
2.  Front map light (See FRONT MAP LIGHT REMOVAL/INSTALLATION.)
3.  Sunvisor (See SUNVISOR REMOVAL/INSTALLATION.)
4.  Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)
5.  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
6.  Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
7.  Lower decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
8.  Bonnet release lever (See BONNET RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)
9.  Fuel-filler lid opener lever (See FUEL-FILLER LID OPENER AND LEVER REMOVAL/INSTALLATION.)
10.  Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
11.  Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
12.  B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
13.  Adjust anchor cover on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
14.  Upper anchor installation bolt on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION.)
15.  B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
16.  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)
17.  Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)
18.  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
19.  Bass-box (with Bose®) (See BASS-BOX REMOVAL/INSTALLATION.)
20.  Third-row seat cushion (See THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION.)
21.  Third-row seat back component (See THIRD-ROW SEAT BACK COMPONENT REMOVAL/INSTALLATION.)
22.  Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
23.  D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)
24.  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
25.  Headliner (See HEADLINER REMOVAL/INSTALLATION.)

3.  Remove the rear map light. (See REAR MAP LIGHT REMOVAL/INSTALLATION.)

4.  Apply battery positive voltage to rear map light terminal A, and connect the ground to terminal B.

ac8jjw00002724

5.  Verify that the LED turns on.

•  If the led does not turn on, replace the rear map light. (See REAR MAP LIGHT REMOVAL/INSTALLATION.)