EVAPORATOR TEMPERATURE SENSOR REMOVAL/INSTALLATION

id074000801100

Warning

•  Handling the driver-side air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the driver-side air bag module. (See AIR BAG SYSTEM SERVICE WARNINGS [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See AIR BAG SYSTEM SERVICE CAUTIONS [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See AIR BAG SYSTEM SERVICE WARNINGS [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See AIR BAG SYSTEM SERVICE CAUTIONS [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

Note

•  When removing the driver-side air bag module, it is necessary to rotate the steering wheel. If the ignition has been switched off with the driver's door closed, the steering wheel will be locked.Perform the procedure from Steps 1-3 so that the steering wheel will not be locked.

1.  Switch the ignition ON (engine off or on).

2.  Open the driver's door.

3.  Switch the ignition off.

4.  Disconnect the negative battery terminal and wait for 1 min or more. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

5.  Discharge the refrigerant. (See REFRIGERANT RECOVERY.)(See REFRIGERANT CHARGING.)

6.  Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [SKYACTIV-D 2.2].) (See ENGINE COOLANT REPLACEMENT [SKYACTIV-G 2.5].)

7.  Remove the following parts:

(1)  Plug hole plate (SKYACTIV-G 2.5) (See PLUG HOLE PLATE REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)

(2)  Engine cover (SKYACTIV-D 2.2) (See ENGINE COVER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

(3)  Battery (R.H.D.) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-D 2.2].) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.5].)

(4)  Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)

(5)  Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

(6)  A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION.)

(7)  Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE REMOVAL [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE REMOVAL [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].)

(8)  Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

(9)  Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

(10)  Lower column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

(11)  Lower decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(12)  Upper decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(13)  Meter hood No.1 (See METER HOOD REMOVAL/INSTALLATION.)

(14)  Center display (See CENTER DISPLAY REMOVAL/INSTALLATION.)

(15)  Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

(16)  Meter hood No.2 (See METER HOOD REMOVAL/INSTALLATION.)

(17)  Active driving display (with Active driving display) (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION.)

(18)  Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)

(19)  Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

(20)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(21)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)

(22)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)

(23)  Rear console panel (See REAR CONSOLE PANEL REMOVAL/INSTALLATION.)

(24)  Rear cooler duct (See REAR COOLER DUCT REMOVAL/INSTALLATION.)

(25)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

(26)  Bonnet release lever (See BONNET RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION.)

(27)  Fuel-filler lid opener lever (See FUEL-FILLER LID OPENER AND LEVER REMOVAL/INSTALLATION.)

(28)  Driver-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(29)  Clock spring (See CLOCK SPRING REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See CLOCK SPRING REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

(30)  Wiper and washer switch (See WIPER AND WASHER SWITCH REMOVAL/INSTALLATION.)

(31)  Light switch (See LIGHT SWITCH REMOVAL/INSTALLATION.)

(32)  Steering shaft (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

(33)  Center lower panel (See CENTER LOWER PANEL REMOVAL/INSTALLATION.)

(34)  Indicator unit (See INDICATOR UNIT REMOVAL/INSTALLATION.)

(35)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(36)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

(37)  Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)

(38)  Selector lever component (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

(39)  Selector lever bracket (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION.)

(40)  SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM].) (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

(41)  Windshield wiper arm and blade (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

(42)  Cowl grille (See COWL GRILLE REMOVAL/INSTALLATION.)

(43)  Dashboard (See DASHBOARD REMOVAL/INSTALLATION.)

(44)  Front heat duct (See FRONT HEAT DUCT REMOVAL/INSTALLATION.)

(45)  Blower unit (See BLOWER UNIT REMOVAL/INSTALLATION.)

(46)  Foot support (See FOOT SUPPORT REMOVAL/INSTALLATION.)

(47)  Front A/C unit (See FRONT A/C UNIT REMOVAL/INSTALLATION.)

8.  Remove the front evaporator temperature sensor. (See FRONT A/C UNIT DISASSEMBLY/ASSEMBLY.)

9.  Install in the reverse order of removal.

10.  Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [SKYACTIV-D 2.2].) (See ENGINE COOLANT LEAKAGE INSPECTION [SKYACTIV-G 2.5].)

11.  Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)